Toilet Problems

Leaks on the outside of the toilet can cause significant damage and leakage through the floor. The advantage in this case is that water losses are easily detected. Problems are sometimes recorded in the area that connects the bowl to the floor. Other times, the leaks have their origin in bad seals. In many of these cases, it is necessary to disassemble the toilet or cistern to perform repairs.

Problems with the toilet

In order to solve the problems of water loss in toilets, it is often necessary to remove the latter to replace the gasket and sometimes it is also necessary to remove the fixing screws and the cistern mechanism. It is necessary to take note of the brand of the tank to buy a kit with all the necessary elements for the repair.

The foam seal is then removed, which enables the water to be sealed between the toilet and the cistern, the edges of the orifice are cleaned to remove scale and the new mechanism is introduced into the cistern. From the outside, the PVC nut is placed in the thread and it locks to compress the joint. Finally, a new foam seal is installed on the nut and, again, the tank on the toilet.

Pipe gasket leaks

When leaks are spotted between the exhaust pipe and the toilet, it is necessary to disassemble the latter. To do this, shut off the water tap, empty the cistern and disconnect the water inlet pipe to the tank. It is then removed from the wall and the retaining brackets removed. To release the toilet from the floor, remove the screws that fix it to the floor. After unscrewing, carefully swing the toilet to loosen the adhesive that binds it to the floor.

When leaks are recorded between the evacuation tube and the toilet, the latter must be removed. Sometimes the solution is to replace the sealing gasket of the sleeve. In this case, after dismantling the toilet, remove the damaged seal and cut the adjusting ring with a metal saw.

If all else fails then you can always call a professional. They know the best practice and will always get the job done.


How to remove a garbage disposal unit

A sink garbage disposal like this bestgarbagedisposalreviews.net/insinkerator-badger-5/, destroys food particles from the sink directly, so you do not have a spoon out and throw them away. The sink drain leads directly to the chopping mechanism that cuts the food into small pieces and pushes them out through the drain pipe. Removing an old unit allows you to replace it with a newer model, or to make repairs to the engine.

badger

Instructions
• Turn the power to the garbage disposal off at the circuit breaker. Unscrew the cover on the bottom of the base unit. Disconnect the ground wire and pull out the other two connectors.
• Disconnect the dishwasher hose by loosening the screw holding it in place in the garbage disposal. Adjustable pliers help to loosen the connection, then remove the outer hose.
• Loosen the nut holding the discharge tube to the arrangement. Pull the discharge pipe from the arrangement.
Turn the lower part of the elimination unit and also the assembly of the ring in a counterclockwise direction. Pull off the assembly.
• Loosen the three bolts holding the mount in place under the sink. Remove the mounting and rubber seal from underneath the unit. The drain flange will come out with the assembly.


New Plumbing Tips

Heres some quick plumbing tips that you probably don’t already know.  They can save you time and money.

sink

Home Trick # 1:
Sink drain clearing
A single cup of vinegar or salt and one of baking soda should be poured regularly at a rate of one cup for every two liters of boiling water.

Home Trick # 2:
Leaky faucet
If the faucet drips and at that moment you cant repair it, there is a homemade trick that eliminates that sound which sucks, especially at night. A string should be attached from the tap to the drain. In this way you will not hear the annoying noise of the drops, as the water will slide silently along the string.

Home Trick # 3:
Easy to put on and remove faucets
If a faucet needs to be placed, an infallible home trick is to grease the nuts with a little petroleum jelly which makes it easier to screw them together.  We recommend that if you dont know much about plumbing to just call a professional instead.

Home Trick # 4:
Remove and replace the silicone in the bathtub
To avoid problems, the silicone seal of the bathtub must be repaired every year. To do this, the previous sealing with ether or oil must be removed and scraped with a sharp blade until it is completely detached. The area is then scrubbed, allowed to dry and the new layer of silicone replaced.


Tips to Save Water

waterDrinking water is a scarce resource and one that it is essential to preserve. So here are some tricks for saving water at home. If we don’t become aware that water is a scarce commodity, it is sometimes difficult to realize the waste that we are responsible for each day. It must be said that opportunities to waste drinking water are common in everyday life.Rest assured, it is possible to achieve water savings without falling into extremes and discomfort. Simply apply a few simple things in every room of the house.

Reduce Bathroom Water Usage

This is undoubtedly the most affected part of the house by waste. Between the water used for personal hygiene and that which is intended to expel our waste, the bathroom and the toilet will be our first stop to save water.

  • Do not let the water run while shaving, washing hands or teeth. This simple gesture will reduce your water consumption by a few liters.
  • Equip taps with flow reducers. They are sometimes called aerators or water-saving aerators. Regardless of the name they bear they reduce the water consumption of 15 liters / minute to 5 liters / minute (depending on the model)
  • Do 5-minute showers or baths and use on average 130L less. By closing the water during soaping you can save 20 liters more.
  • Make sure that the washing machine is full before starting it. If the model is equipped with a Eco function use it.

save

 

Saving Water in the Kitchen

Another important room in the house is the kitchen. Follow these tips for big savings.

  • Wash vegetables over a basin to reuse water which can then be used to water plants and flowers.
  • Make sure that the dishwasher is completely full before starting it. Some models are equipped with a touch Eco or Half-load, use them!
  • If doing the dishes by hand, do not let the water run! Instead fill 2 tanks (1 for washing, one for rinsing)
  • Note that by not closing the tap it uses less than 50L of water to clean the dishes instead of only 15 to 20 liters filling the tanks.

Reduce Water Usage Outdoors

The garden is the last place that you can save water.

  • Use a sprinkler system and drip or soaker hose that allows you to regulate the pressure and therefore the amount of water distributed by limiting its dripping.
  • Have mulch around the crops to retain moisture from dew and watering.
  • Use a watering hose to limit the constant running phenomenon and use less water for the same result.
  • Water during the evening to avoid fast evaporation due to the sun.
  •  Use a maximum of other water resources. The water from the well can be captured easily and used to water the garden for free.
  • Installing a rainwater harvesting system to benefit from free and renewable source of water.

In Conclusion

We have given many tips to reduce drinking water consumption and reduce bills. None of these actions will revolutionize our comfort and, with a little good will and a lot of mobilization of the citizens, we have the power to contribute to the limitation of our water problems.